Slow progress on the RS10V

So I've had a busy weekend but decided to have a little go at the RS10V this evening.

I carefully drilled the pilot holes for the tremolo studs then waved the tremolo and routing templates at the body. I'm going to have to route the body a fair bit deeper for the tremolo to be any use as the Speedloader has quite a lot of gubbins at the back.

Despite this the guided router bit I have is quite deep so I'll probably still have to raise the router template up on blocks. I think I need to get another shorter bit. I also need some more varied drill bits as the tremolo studs look to fit an approximately 9.8mm hole rather than a 10mm one.

This conspired to make me give up on this for tonight, but I may have another look next weekend.